Aeroflow Blower Stud Kit Black Studs AF37-0602BLK G7 they also come with a

they also come with a grey output wire that is used to send a tach signal and set your built in rev limiter or trigger your aftermarket EFI system

The equipped high quality harden rubber and pillow ball bushings provide greater handling response over the factory components

Stainless Steel Straight AN Bulkhead

NOTE: CRANK SENSOR BRACKETS ARE ONLY AVAILABLE IN BLACK

Aeroflow Blower Stud Kit Black Studs AF37-0602BLK G7 they also come with aBlack Studs & Nuts Blower stud kits are machined from aerospace quality 6061 T6 aluminium and are black or silver anodized. In the event of a severe backfire, these studs will break and allow separation of manifold and blower. This protects engine and blower from unnecessary damage. Kit comes complete with anodized aluminium studs, 12 point, quality steel nuts and hardened steel washers. Overall Length 63mm (2 1 2"). Torque to 15 ft lbs (20Nm).