Pay in 4 interest-free payments of $45.00 Learn more
Ships within 48 hours · Estimated delivery Aug 17 - Aug 22
Available in either Single Phase to run on standard 220V Power
please check this diameter to see if it may fit)
when the ways are lubricated via a pump system from the gearbox (Such as the apron on our PM-TL series lathes)
Manual Down Feed on spindle PLUS
ER-40 Adjustable Collet Chuck, D1-5 Mount Power Drawbar Available in either Single PhaseAdjustable runout provides the highest precision possible Very High Quality collet chuck Higher precision than anything you will find near this price A big upgrade from most standard non adjustable collet chucks, but a very reasonable price Precision Balanced for better running at higher speeds D1 5 Camlock Mounting fits any lathe spindle with this mount Complete with spanner wrench Works with any ER 40 (ER 40 collets are required with this, collets
US$ 77.50
US$ 875.00
US$ 14.10
US$ 34.15
US$ 114.00
